This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
creator_pro_3d_printer [2019/05/29 18:20] 99.187.157.162 [Usage Notes] |
creator_pro_3d_printer [2019/09/06 09:54] 24.158.60.179 [Usage Notes] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Creator Pro 3D Printer ===== | + | ===== Creator Pro 3D Printer (Zaniac) ===== |
PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | ||
Line 17: | Line 17: | ||
- create your stl file | - create your stl file | ||
- open FlashPrint - free to download on your machine; also installed on the laptop that controls the TAZ | - open FlashPrint - free to download on your machine; also installed on the laptop that controls the TAZ | ||
- | - use FlashPrint to slice you file | + | - use FlashPrint to slice your file |
- click on Print and select your print options | - click on Print and select your print options | ||
- | - save the g-code file to an SD card | + | - save the g-code file to an SD card (the SD card slot is just inside the printer door over the controls) |
- insert the SD card into the printer and print form the SD card | - insert the SD card into the printer and print form the SD card |