creator_pro_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
creator_pro_3d_printer [2019/05/29 18:21] 99.187.157.162 [Usage Notes] |
creator_pro_3d_printer [2019/09/06 09:54] 24.158.60.179 [Usage Notes] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Creator Pro 3D Printer ===== | + | ===== Creator Pro 3D Printer (Zaniac) ===== |
| PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | ||
| Line 19: | Line 19: | ||
| - use FlashPrint to slice your file | - use FlashPrint to slice your file | ||
| - click on Print and select your print options | - click on Print and select your print options | ||
| - | - save the g-code file to an SD card | + | - save the g-code file to an SD card (the SD card slot is just inside the printer door over the controls) |
| - insert the SD card into the printer and print form the SD card | - insert the SD card into the printer and print form the SD card | ||
creator_pro_3d_printer.txt · Last modified: 2019/11/24 11:11 by 136.55.187.214 · Currently locked by: 52.14.126.74
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
