laser_cutter_engraver
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
laser_cutter_engraver [2018/04/10 20:14] 66.190.155.97 |
laser_cutter_engraver [2019/07/02 09:00] 96.36.234.213 |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| Chassis Cleaned and Lubricated: 1/7/18 \\ | Chassis Cleaned and Lubricated: 1/7/18 \\ | ||
| Mirrors Cleaned: 04/10/18 \\ | Mirrors Cleaned: 04/10/18 \\ | ||
| - | Lens Cleaned: 1/7/18 \\ | + | Lens Cleaned: 4/10/18 \\ |
| Chassis should be lubricated with sewing machine oil. | Chassis should be lubricated with sewing machine oil. | ||
| Line 45: | Line 45: | ||
| Cut Speed: 10 Power: 60 | Cut Speed: 10 Power: 60 | ||
| Engrave Speed: 200 Power: 20 | Engrave Speed: 200 Power: 20 | ||
| + | ==3mm (1/8") acrylic/plexiglass== | ||
| + | Cut Speed: 1.75"/s Power: 60W Passes: 3 | ||
| ==Soft Pine== | ==Soft Pine== | ||
| Engrave Speed: 250 Power: 30 | Engrave Speed: 250 Power: 30 | ||
laser_cutter_engraver.txt ยท Last modified: 2019/07/02 09:01 by 96.36.234.213
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
