laser_rotary_attachment
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
laser_rotary_attachment [2019/05/21 11:30] 24.158.60.179 |
laser_rotary_attachment [2019/06/08 15:11] 24.158.60.179 |
||
|---|---|---|---|
| Line 33: | Line 33: | ||
| When you are done, change all of these settings back to their original values and Write them (other than the Workpiece Diameter or Circumference). Also change the following: | When you are done, change all of these settings back to their original values and Write them (other than the Workpiece Diameter or Circumference). Also change the following: | ||
| * change the y-axis keypad acceleration to 4,500 | * change the y-axis keypad acceleration to 4,500 | ||
| - | * set the cut parameters max acceleration to 10,000 | + | * set the cut parameters max acceleration to 2,000, the idle acceleration to 2,000, and the min acceleration to 400 |
| * set the engraving parameters Y acceleration to 10,000 | * set the engraving parameters Y acceleration to 10,000 | ||
| Line 39: | Line 39: | ||
| Settings: | Settings: | ||
| - | I found a speed of 100 and power of 20 seemed to work well on the pint glasses I was using to test the rotary. You may also want to wipe your piece with a wet piece of denim (or paper towel) to remove any tiny bits of glass still clinging to the piece. | + | I found a speed of 100 and power of 20 with 300 dpi seemed to work well on the pint glasses I was using to test the rotary. You may also want to wipe your piece with a wet piece of denim (or paper towel) to remove any tiny bits of glass still clinging to the piece. |
laser_rotary_attachment.txt ยท Last modified: 2019/06/08 15:11 by 24.158.60.179
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
