Site Tools


matter_and_form_3d_scanner

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
matter_and_form_3d_scanner [2016/12/26 10:45]
38.96.208.3
matter_and_form_3d_scanner [2016/12/26 10:46]
38.96.208.3 [Instructions]
Line 37: Line 37:
  ​Calibrating only needs to be done when the scans are looks bad or when the scanner is moved and the camera/​lasers might have been jostled. ​  ​Calibrating only needs to be done when the scans are looks bad or when the scanner is moved and the camera/​lasers might have been jostled. ​
  
- With each scan the the camera exposure is adjusted for the lighting, so just changing the lighting does not require re-calibration. I've tried several lighting setups and found that the scanner worked well in all of them as long as the shadows were not harsh. I tried it in my basement directly under one of the 4 recessed lights and it worked pretty good. Even, diffuse light created by the overhead lighting we have in the space will work very well.+ With each scan the camera exposure is adjusted for the lighting, so just changing the lighting does not require re-calibration. I've tried several lighting setups and found that the scanner worked well in all of them as long as the shadows were not harsh. I tried it in my basement directly under one of the 4 recessed lights and it worked pretty good. Even, diffuse light created by the overhead lighting we have in the space will work very well.
  
  Not much more I can add to their instructions,​ it pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single Color (its still does a color scan), and then wait. Scans are slow. You can clean up the finished scan to remove random points and the scanner bed, then save it.  Not much more I can add to their instructions,​ it pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single Color (its still does a color scan), and then wait. Scans are slow. You can clean up the finished scan to remove random points and the scanner bed, then save it.
matter_and_form_3d_scanner.txt ยท Last modified: 2016/12/26 10:52 by 38.96.208.3