Site Tools


matter_and_form_3d_scanner

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
matter_and_form_3d_scanner [2016/12/26 10:45]
38.96.208.3
matter_and_form_3d_scanner [2016/12/26 10:52]
38.96.208.3 [Instructions]
Line 37: Line 37:
  ​Calibrating only needs to be done when the scans are looks bad or when the scanner is moved and the camera/​lasers might have been jostled. ​  ​Calibrating only needs to be done when the scans are looks bad or when the scanner is moved and the camera/​lasers might have been jostled. ​
  
- With each scan the the camera exposure is adjusted for the lighting, so just changing the lighting does not require re-calibration. I've tried several lighting setups and found that the scanner worked well in all of them as long as the shadows were not harsh. I tried it in my basement directly under one of the 4 recessed lights and it worked pretty good. Even, diffuse light created by the overhead lighting we have in the space will work very well.+ With each scan the camera exposure is adjusted for the lighting, so just changing the lighting does not require re-calibration. I've tried several lighting setups and found that the scanner worked well in all of them as long as the shadows were not harsh. I tried it in my basement directly under one of the 4 recessed lights and it worked pretty good. Even, diffuse light created by the overhead lighting we have in the space will work very well.
  
- Not much more I can add to their instructions,​ it pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single ​Color (its still does a color scan), and then wait. Scans are slow. You can clean up the finished scan to remove random points and the scanner bed, then save it.+ Not much more I can add to their instructions,​ it'​s ​pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single ​Coloured ​(it still does a color scan), and then wait. Scans are slow (10-15 min per rotation * the number of elevation steps). You can clean up the finished scan to remove random points and the scanner bed, then save it.
  
 ==== My Tips: ==== ==== My Tips: ====
matter_and_form_3d_scanner.txt ยท Last modified: 2016/12/26 10:52 by 38.96.208.3