This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
new_member_general_info [2019/07/25 09:50] 24.158.60.179 |
new_member_general_info [2019/07/25 09:51] (current) 24.158.60.179 |
||
---|---|---|---|
Line 10: | Line 10: | ||
- **Safety** - Be sure the lights are out and the space is locked if you leaving and there is no one else in the space at that moment. Don't assume someone who left is coming right back. Also, never leave the outside doors propped open after hours. | - **Safety** - Be sure the lights are out and the space is locked if you leaving and there is no one else in the space at that moment. Don't assume someone who left is coming right back. Also, never leave the outside doors propped open after hours. | ||
- **Music** - We have bluetooth speakers hooked up to listen to music while working. The password to attach, if you are asked, is 1234. Please be respectful about playing music when others are using the space as well. | - **Music** - We have bluetooth speakers hooked up to listen to music while working. The password to attach, if you are asked, is 1234. Please be respectful about playing music when others are using the space as well. | ||
- | - **Free supplies** - The plastic filament for the TAZ and Zaniac printers is free for members. You may also use any laser scraps that are in the labeled scrap pile (top shelf only!) beneath the table next to the lasers. Other genrela office supplies such as tape, paper towels, glues, etc. are also free to members. The resin for the Formlabs printer is NOT free, and the resin is expensive, so **make sure you understand the cost and process before you print!** Members do get a free allowance for resin each month ($5). Every time you print with the Formlabs printer, make sure your name is in the filename of your print. The printer will keep a log of prints done and the amount of resin used, and we will set up each month with members who use more than $5 of resin in that month. | + | - **Free supplies** - The plastic filament for the TAZ and Zaniac printers is free for members. You may also use any laser scraps that are in the labeled scrap pile (top shelf only!) beneath the table next to the lasers. Other general office supplies such as tape, paper towels, glues, etc. are also free to members. The resin for the Formlabs printer is NOT free, and the resin is expensive, so **make sure you understand the cost and process before you print!** Members do get a free allowance for resin each month ($5). Every time you print with the Formlabs printer, make sure your name is in the filename of your print. The printer will keep a log of prints done and the amount of resin used, and we will set up each month with members who use more than $5 of resin in that month. |