Site Tools


new_member_general_info

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Last revision Both sides next revision
new_member_general_info [2019/07/25 09:33]
24.158.60.179 created
new_member_general_info [2019/07/25 09:50]
24.158.60.179
Line 9: Line 9:
   - **Safety** - Never use equipment if you have nbot been checked out on it and you do not feel confident in your ability to use it in a manner that is safe for everyone and the equipment. ​ If you have any questions about a machine, please ask!  Other members are generally happy to help you or point you to someone who can.   - **Safety** - Never use equipment if you have nbot been checked out on it and you do not feel confident in your ability to use it in a manner that is safe for everyone and the equipment. ​ If you have any questions about a machine, please ask!  Other members are generally happy to help you or point you to someone who can.
   - **Safety** - Be sure the lights are out and the space is locked if you leaving and there is no one else in the space at that moment. ​ Don't assume someone who left is coming right back.  Also, never leave the outside doors propped open after hours.   - **Safety** - Be sure the lights are out and the space is locked if you leaving and there is no one else in the space at that moment. ​ Don't assume someone who left is coming right back.  Also, never leave the outside doors propped open after hours.
 +  - **Music** - We have bluetooth speakers hooked up to listen to music while working. ​ The password to attach, if you are asked, is 1234.  Please be respectful about playing music when others are using the space as well.
 +  - **Free supplies** - The plastic filament for the TAZ and Zaniac printers is free for members. ​ You may also use any laser scraps that are in the labeled scrap pile (top shelf only!) beneath the table next to the lasers. ​ Other genrela office supplies such as tape, paper towels, glues, etc. are also free to members. ​ The resin for the Formlabs printer is NOT free, and the resin is expensive, so **make sure you understand the cost and process before you print!** ​ Members do get a free allowance for resin each month ($5).  Every time you print with the Formlabs printer, make sure your name is in the filename of your print. ​ The printer will keep a log of prints done and the amount of resin used, and we will set up each month with members who use more than $5 of resin in that month.
new_member_general_info.txt ยท Last modified: 2019/07/25 09:51 by 24.158.60.179