pov_globe
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
pov_globe [2017/08/29 15:20] 66.190.155.97 |
pov_globe [2017/08/29 15:21] 66.190.155.97 |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| I used an LED strip (neopixels are apparently not fast enough for a good POV display, so I used DotStar) instead of individual RGB leds and just glued it to the frame with contact cement. | I used an LED strip (neopixels are apparently not fast enough for a good POV display, so I used DotStar) instead of individual RGB leds and just glued it to the frame with contact cement. | ||
| - | I initially used a nano as the controller and and ESP8266-01 to give it WiFi capability, but Robert suggested I just use an ESP8266 Huzzah breakout board as the controller with built in WiFi. The built-in WiFi simplified the code considerably, and the faster speed (80 MHz vs 16 MHz) helped a lot as well. Robert even gave me one to use! Thanks, Robert! (and while I'm at it, thanks also to Avi for helping me understand how to write data to the LED strip without using a library - this really sped things up.) | + | I initially used a nano as the controller and an ESP8266-01 to give it WiFi capability, but Robert suggested I just use an ESP8266 Huzzah breakout board as the controller with built in WiFi. The built-in WiFi simplified the code considerably, and the faster speed (80 MHz vs 16 MHz) helped a lot as well. Robert even gave me one to use! Thanks, Robert! (and while I'm at it, thanks also to Avi for helping me understand how to write data to the LED strip without using a library - this really sped things up.) |
| The power supply is one we had at the space, salvaged from an old PC, and the motor controller was a cheap one ordered off of eBay. And, after many attempts at balancing the rotor with no armature holding the top stationary, I finally had to admit that a stabilizing arm was a necessity. The total cost of the globe was probably under $100 (but not by very much) with most of the expense coming from the LED strip and the motor. You could cut the cost considerably, I think, by using individual LEDs rather than a strip, but boy would you add a lot of work. | The power supply is one we had at the space, salvaged from an old PC, and the motor controller was a cheap one ordered off of eBay. And, after many attempts at balancing the rotor with no armature holding the top stationary, I finally had to admit that a stabilizing arm was a necessity. The total cost of the globe was probably under $100 (but not by very much) with most of the expense coming from the LED strip and the motor. You could cut the cost considerably, I think, by using individual LEDs rather than a strip, but boy would you add a lot of work. | ||
pov_globe.txt ยท Last modified: 2018/01/10 12:40 by 66.190.155.97
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
