shapeoko_3_cnc_router
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
shapeoko_3_cnc_router [2016/12/28 15:18] 66.190.155.97 [Usage Notes] |
shapeoko_3_cnc_router [2017/10/11 10:42] 66.190.155.97 [Usage Notes] |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| * For post processing, choose carbide3d.cps for the Post Configuration. | * For post processing, choose carbide3d.cps for the Post Configuration. | ||
| * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you can create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. | * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you can create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. | ||
| - | * For poplar, cutting 5mm depth, a feed rate of 600 mm/sec gave good results. At 800 mm/sec, the CNC would skip teeth on the belts. | + | * For poplar, cutting 5mm depth, a feed rate of 600 mm/min gave good results. At 800 mm/min, the CNC would skip teeth on the belts. |
shapeoko_3_cnc_router.txt ยท Last modified: 2017/10/11 10:42 by 66.190.155.97
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
