Differences

This shows you the differences between two versions of the page.

--- taz_6_3d_printer [2016/11/01 16:20]
66.190.155.97 [Change Extruder Head]
+++ taz_6_3d_printer [2020/06/20 17:08] (current)
108.227.249.183
@@ Line 9: / Line 9: @@
 **Arrival Date**: June 2016 \\
 **Working Condition**: yes \\
-**Contact**: Robert S. \\
+**Contact**: ? \\
 **Manual**: [[https://download.lulzbot.com/TAZ/6.0/documentation/manual/TAZ-6-Manual.pdf|Click here]]
 ====Usage Notes====
@@ Line 22: / Line 22: @@
   - In Cura, go to Machine > Machine Settings. Top right there is an option to "Change Tool Head"
     - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder").
-  - Go to Machine > Install Custom Firmware
+  - Go to Machine > Install Default Firmware
-  - Go to Desktop/Cura Firmware/ and select the firmware for either the Flexy or normal extruder head
   - Good to go
+====Adjust Belt Tension====
+Tightening the belt is hard, but this is the workflow that I found that worked:
+  - loosen up the screws on the bearing that holds the belt
+  - push that bearing forward so it loosens up the belt
+  - undo the screw that holds one side of the belt, and pull it tighter. You'll have to hold everything in place or the bed will just slide
+  - tighten the end of the belt down
+  - tighten the bearing back down
+  - if the belt is too tight now, loosen the end and let a little slack in until it seems good
+It's a lot easier to add slack back in than tighten it down.

Asheville Makers Wiki