This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
laser_rotary_attachment [2019/01/03 18:45] 24.158.60.179 |
laser_rotary_attachment [2019/01/03 18:47] 24.158.60.179 |
||
---|---|---|---|
Line 11: | Line 11: | ||
**Working Condition**: yes \\ | **Working Condition**: yes \\ | ||
**Contact**: Zak S. \\ | **Contact**: Zak S. \\ | ||
- | |||
NEVER plug in or unplug the rotary attachment or the y-axis motor when the laser is powered on. | NEVER plug in or unplug the rotary attachment or the y-axis motor when the laser is powered on. | ||
To use the rotary attachment, set the following parameters on the laser by opening LightBurn and going to Edit/Machine Settings: | To use the rotary attachment, set the following parameters on the laser by opening LightBurn and going to Edit/Machine Settings: | ||
- | - Under Rotary Parameters, set Enable Rotary to True | + | * Under Rotary Parameters, set Enable Rotary to True |
- | - Under Y Axis Settings, set Enable Homing to False | + | * Under Y Axis Settings, set Enable Homing to False |
- | - Under Y Axis Settings, set Max Speed to 75 rather than 300 | + | * Under Y Axis Settings, set Max Speed to 75 rather than 300 |
- | - Under Y Axis Settings, set Max Acceleration to 100 rather than 2,000 | + | * Under Y Axis Settings, set Max Acceleration to 100 rather than 2,000 |
Then click on Write. If you just click OK, changes will not be saved. | Then click on Write. If you just click OK, changes will not be saved. |