This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
laser_rotary_attachment [2019/04/24 13:51] 24.158.60.179 |
laser_rotary_attachment [2019/04/24 14:00] 24.158.60.179 |
||
---|---|---|---|
Line 32: | Line 32: | ||
When you are done, change all of these settings back to their original values (other than the Workpiece Diameter or Circumference). Then //__**turn off the machine**__//, unplug and remove the rotary attachment, and raise the bed back up so that the next person can use the laser for cutting or engraving flat stock. | When you are done, change all of these settings back to their original values (other than the Workpiece Diameter or Circumference). Then //__**turn off the machine**__//, unplug and remove the rotary attachment, and raise the bed back up so that the next person can use the laser for cutting or engraving flat stock. | ||
+ | |||
+ | Settings: | ||
+ | I found a speed of 100 and power of 20 seemed to work well on the pint glasses I was using to test the rotary. You may also want to wipe your piece with a wet piece of denim (or paper towel) to remove any tiny bits of glass still clinging to the piece. |