This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
matter_and_form_3d_scanner [2016/12/26 15:31] 38.96.208.3 |
matter_and_form_3d_scanner [2016/12/26 15:45] 38.96.208.3 |
||
---|---|---|---|
Line 30: | Line 30: | ||
==== Instructions ==== | ==== Instructions ==== | ||
- | * [[https://matterandform.net/downloads/Matter-and-Form_3D-Scanner_User-Manual.pdf?d=2016-08-17|Uder Manual PDF]] | + | * [[https://matterandform.net/downloads/Matter-and-Form_3D-Scanner_User-Manual.pdf?d=2016-08-17|User Manual PDF]] |
* [[https://matterandform.net/downloads/Matter-and-Form_3D-Scanner_Dos-and-Donts_EN.pdf|Do's and Dont's PDF]] | * [[https://matterandform.net/downloads/Matter-and-Form_3D-Scanner_Dos-and-Donts_EN.pdf|Do's and Dont's PDF]] | ||
* [[https://www.youtube.com/watch?v=tOCBuoq8Oag|Basics Scanning Video]] | * [[https://www.youtube.com/watch?v=tOCBuoq8Oag|Basics Scanning Video]] | ||
* [[https://www.youtube.com/watch?v=MHal2YmLTJk|Advanced Scanning Video]] | * [[https://www.youtube.com/watch?v=MHal2YmLTJk|Advanced Scanning Video]] | ||
- | Not much more I can add to their instructions, it pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single Color (its still does a color scan), and then wait. Scans are slow. You can clean up the finished scan to remove random points and the scanner bed, then save it. | + | Calibrating only needs to be done when the scans are looks bad or when the scanner is moved and the camera/lasers might have been jostled. |
+ | |||
+ | With each scan the the camera exposure is adjusted for the lighting, so just changing the lighting does not require re-calibration. I've tried several lighting setups and found that the scanner worked well in all of them as long as the shadows were not harsh. I tried it in my basement directly under one of the 4 recessed lights and it worked pretty good. Even, diffuse light created by the overhead lighting we have in the space will work very well. | ||
+ | |||
+ | Not much more I can add to their instructions, it pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single Color (its still does a color scan), and then wait. Scans are slow. You can clean up the finished scan to remove random points and the scanner bed, then save it. | ||
==== My Tips: ==== | ==== My Tips: ==== |