matter_and_form_3d_scanner
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
matter_and_form_3d_scanner [2016/12/26 15:34] 38.96.208.3 |
matter_and_form_3d_scanner [2016/12/26 15:34] 38.96.208.3 |
||
|---|---|---|---|
| Line 35: | Line 35: | ||
| * [[https://www.youtube.com/watch?v=MHal2YmLTJk|Advanced Scanning Video]] | * [[https://www.youtube.com/watch?v=MHal2YmLTJk|Advanced Scanning Video]] | ||
| - | Calibrating only needs to be done when the scans are looks bad. With each scan the the camera exposure is adjusted for the lighting. Calibration is not affected by lighting. | + | Calibrating only needs to be done when the scans are looks bad. With each scan the the camera exposure is adjusted for the lighting. Calibration is not affected by lighting. |
| - | Not much more I can add to their instructions, it pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single Color (its still does a color scan), and then wait. Scans are slow. You can clean up the finished scan to remove random points and the scanner bed, then save it. | + | |
| + | Not much more I can add to their instructions, it pretty straight forward. Put the item on the scanner, open the software, click New Scan, select Single Color (its still does a color scan), and then wait. Scans are slow. You can clean up the finished scan to remove random points and the scanner bed, then save it. | ||
| ==== My Tips: ==== | ==== My Tips: ==== | ||
matter_and_form_3d_scanner.txt · Last modified: 2016/12/26 15:52 by 38.96.208.3
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
