This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
shapeoko_3_cnc_router [2016/05/21 01:47] 99.187.157.82 [Shapeoko 3 CNC Router] |
shapeoko_3_cnc_router [2016/05/29 18:15] 24.182.94.75 [Usage Notes] |
||
---|---|---|---|
Line 13: | Line 13: | ||
==== Safety ==== | ==== Safety ==== | ||
+ | |||
+ | |||
+ | ==== Usage Notes ==== | ||
+ | === General === | ||
+ | |||
+ | ===Fusion 360 === | ||
+ | * For post processing, choose carbide3d.cps for the Post Configuration. | ||
+ | * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you can create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. |