This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
shapeoko_3_cnc_router [2016/05/27 15:31] 99.187.157.82 |
shapeoko_3_cnc_router [2016/05/29 18:14] 24.182.94.75 [Usage Notes] |
||
---|---|---|---|
Line 19: | Line 19: | ||
===Fusion 360 === | ===Fusion 360 === | ||
- | To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you cna create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. | + | * For post processing, choose carbide3d.cps for the Post Configuration. |
+ | * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you cna create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. |