This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
shapeoko_3_cnc_router [2016/05/29 18:14] 24.182.94.75 [Usage Notes] |
shapeoko_3_cnc_router [2016/06/24 18:16] 24.182.94.75 [Usage Notes] |
||
---|---|---|---|
Line 3: | Line 3: | ||
PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | ||
- | **Owner/Loaner**: TBD \\ | + | **Owner/Loaner**: Asheville Makers \\ |
- | **Donated By**: TBD \\ | + | **Donated By**: Steve A. \\ |
**Serial Number**: N/A \\ | **Serial Number**: N/A \\ | ||
**Make/Model**: [[http://carbide3d.com/shapeoko/|Shapeoko 3]] \\ | **Make/Model**: [[http://carbide3d.com/shapeoko/|Shapeoko 3]] \\ | ||
- | **Arrival Date**: TBD \\ | + | **Arrival Date**: June 2016 \\ |
**Working Condition**: yes \\ | **Working Condition**: yes \\ | ||
**Contact**: Steve A. \\ | **Contact**: Steve A. \\ | ||
Line 16: | Line 16: | ||
==== Usage Notes ==== | ==== Usage Notes ==== | ||
+ | === Class Materials === | ||
+ | * [[Presentation]]https://drive.google.com/open?id=10IlcqnPNnpf4Khr_hTe_sQKYdcUZgd8OPOhvtuL0xMw | ||
+ | * Files for cutting coaster in pine | ||
+ | * files for cutting coaster in poplar | ||
+ | |||
=== General === | === General === | ||
- | ===Fusion 360 === | + | === Fusion 360 === |
* For post processing, choose carbide3d.cps for the Post Configuration. | * For post processing, choose carbide3d.cps for the Post Configuration. | ||
- | * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you cna create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. | + | * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you can create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. |