This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
shapeoko_3_cnc_router [2016/06/20 21:02] 99.187.157.82 |
shapeoko_3_cnc_router [2016/06/24 18:16] 24.182.94.75 [Usage Notes] |
||
---|---|---|---|
Line 16: | Line 16: | ||
==== Usage Notes ==== | ==== Usage Notes ==== | ||
+ | === Class Materials === | ||
+ | * [[Presentation]]https://drive.google.com/open?id=10IlcqnPNnpf4Khr_hTe_sQKYdcUZgd8OPOhvtuL0xMw | ||
+ | * Files for cutting coaster in pine | ||
+ | * files for cutting coaster in poplar | ||
+ | |||
=== General === | === General === | ||
- | ===Fusion 360 === | + | === Fusion 360 === |
* For post processing, choose carbide3d.cps for the Post Configuration. | * For post processing, choose carbide3d.cps for the Post Configuration. | ||
* To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you can create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. | * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit. For example, you can create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in. |