digital_rose_engine
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
digital_rose_engine [2017/01/14 22:30] 74.243.171.60 |
digital_rose_engine [2017/01/14 22:35] (current) 74.243.171.60 |
||
|---|---|---|---|
| Line 98: | Line 98: | ||
| Camwheels for prototyping designs on Bill's mechanical system might be 3D printed fairly easily. | Camwheels for prototyping designs on Bill's mechanical system might be 3D printed fairly easily. | ||
| + | |||
| + | If it ran from a Pi or laptop could a real interface be built that would allow easier setup and previews of the results? | ||
digital_rose_engine.txt ยท Last modified: 2017/01/14 22:35 by 74.243.171.60
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
