This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
laser_rotary_attachment [2019/01/03 13:39] 24.158.60.179 created |
laser_rotary_attachment [2019/01/03 13:47] 24.158.60.179 |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Laser Rotary Attachment ===== | ||
+ | |||
+ | PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | ||
+ | |||
+ | **Owner/Loaner**: Asheville Makers \\ | ||
+ | **Donated By**: N/A \\ | ||
+ | **Serial Number**: N/A \\ | ||
+ | **Make/Model**: [[https://www.cloudraylaser.com/products/mechanical-parts-rotation-axis-engraving-model-a?variant=45520840968|Cloudray]] \\ | ||
+ | **Arrival Date**: December 2018 \\ | ||
+ | **Manual**: N/A\\ | ||
+ | **Working Condition**: yes \\ | ||
+ | **Contact**: Zak S. \\ | ||
+ | |||
NEVER plug in or unplug the rotary attachment or the y-axis motor when the laser is powered on. | NEVER plug in or unplug the rotary attachment or the y-axis motor when the laser is powered on. | ||
To use the rotary attachment, set the following parameters on the laser by opening LightBurn and going to Edit/Machine Settings: | To use the rotary attachment, set the following parameters on the laser by opening LightBurn and going to Edit/Machine Settings: | ||
- | - Under Rotary Parameters, set Enable Rotary to True | + | * Under Rotary Parameters, set Enable Rotary to True |
- | - Under Y Axis Settings, set Enable Homing to False | + | * Under Y Axis Settings, set Enable Homing to False |
- | - Under Y Axis Settings, set Max Speed to 75 rather than 300 | + | * Under Y Axis Settings, set Max Speed to 75 rather than 300 |
- | - Under Y Axis Settings, set Max Acceleration to 100 rather than 2,000 | + | * Under Y Axis Settings, set Max Acceleration to 100 rather than 2,000 |
Then click on Write. If you just click OK, changes will not be saved. | Then click on Write. If you just click OK, changes will not be saved. |