microprotosystems_dsls3000_cnc_mill
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
microprotosystems_dsls3000_cnc_mill [2017/05/01 11:12] 74.243.171.57 |
microprotosystems_dsls3000_cnc_mill [2017/05/01 13:50] 74.243.171.57 |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| {{:bob:fusion360-units.jpg?200|}} | {{:bob:fusion360-units.jpg?200|}} | ||
| + | Zak clued me in to writing a .stl from Fusion. This option is in the "make" tab. Probably more than one way to do this, but I box selected the whole object and then picked 3D print from the make tab. | ||
| + | It seems that you need to pick something in the refinement dropdown (even if it is the same option) to get fusion to build and display a mesh. Uncheck the send to 3D print utility box and when you click OK it will prompt you for a .stl filename. | ||
| + | |||
| + | {{:bob:fusion-make.jpg?200|}} | ||
| + | |||
| + | can I still type! | ||
microprotosystems_dsls3000_cnc_mill.txt ยท Last modified: 2017/05/01 13:51 by 74.243.171.57
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
