ramps_marlin_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
ramps_marlin_3d_printer [2018/03/01 14:49] 66.190.155.97 |
ramps_marlin_3d_printer [2018/03/01 14:50] 66.190.155.97 [Build Notes] |
||
|---|---|---|---|
| Line 51: | Line 51: | ||
| ==== Build Notes ==== | ==== Build Notes ==== | ||
| A schematic for the heated bed relay board can be found {{:heated_bed_relay_board.pdf|here}}. The connections for this relay board are: | A schematic for the heated bed relay board can be found {{:heated_bed_relay_board.pdf|here}}. The connections for this relay board are: | ||
| - | + 12V from the RAMPS board heater terminal | + | * + 12V from the RAMPS board heater terminal |
| - | - Ground from the RAMPS board heater terminal | + | * - Ground from the RAMPS board heater terminal |
| - | 5V 5V from the power supply | + | * 5V 5V from the power supply |
| - | C Mains common line | + | * C Mains common line |
| - | H Mains hot line | + | * H Mains hot line |
| - | The other two terminals are for the heater. | + | * The other two terminals are for the heater. |
ramps_marlin_3d_printer.txt · Last modified: 2020/04/21 19:24 by 99.187.157.162
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
