Asheville Makers Wiki

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

===== Shapeoko 3 CNC Router =====

PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it.

**Owner/Loaner**: Asheville Makers \\
**Donated By**: Steve A. \\
**Serial Number**: N/A \\
**Make/Model**: [[http://carbide3d.com/shapeoko/|Shapeoko 3]] \\
**Arrival Date**: June 2016 \\
**Assembly Guide**: [[https://drive.google.com/open?id=0ByE4uXHeoDYNenhsS05yazd1OWc|Manual]]\\
**Working Condition**: yes \\
**Contact**: Steve A. \\

==== Safety ====

==== Usage Notes ====
=== Class Materials ===
  * [[https://drive.google.com/open?id=10IlcqnPNnpf4Khr_hTe_sQKYdcUZgd8OPOhvtuL0xMw|Presentation]]
  * [[https://drive.google.com/open?id=0ByE4uXHeoDYNOUFOZ0xQQy1VeGs|Files for cutting coaster in pine]]
  * [[https://drive.google.com/open?id=0ByE4uXHeoDYNOVJTNHUxd01SVmc|Files for cutting coaster in poplar]]

=== General ===
  * Securing the Stock - One good method for securing your stock is to use super glue, activator, and masking tape as described in [[https://www.youtube.com/watch?v=3uTsQ3dYRrk|this video]].
=== Fusion 360 ===
  * For post processing, choose carbide3d.cps for the Post Configuration.
  * To engrave with a V bit in Fusion 360 (e.g. lettering), you can select a chamfer mill as your bit and then edit the bit to create the appropriate V bit.  For example, you can create a 1/4 inch 90 degree V bit with the following settings: Diameter - 0.25 in; Shaft Diameter - 0.25 in; Taper Angle 45 deg; Tip Diameter - 0.001 in.
  * For poplar, cutting 5mm depth, a feed rate of 600 mm/sec gave good results.  At 800 mm/sec, the CNC would skip teeth on the belts.

Please fill all the letters into the box to prove you're human. K T B M P Please keep this field empty:

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported

Asheville Makers Wiki

Site Tools

Page Tools