Differences

This shows you the differences between two versions of the page.

--- taz_6_3d_printer [2016/06/23 12:52]
24.182.94.75
+++ taz_6_3d_printer [2018/01/24 16:23]
66.191.217.105
@@ Line 1: / Line 1: @@
-===== TAZ 6 3D Pringter =====
+===== TAZ 6 3D Printer =====
 PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it.
@@ Line 9: / Line 9: @@
 **Arrival Date**: June 2016 \\
 **Working Condition**: yes \\
-**Contact**: Robert S. \\
+**Contact**: ? \\
+**Manual**: [[https://download.lulzbot.com/TAZ/6.0/documentation/manual/TAZ-6-Manual.pdf|Click here]]
+====Usage Notes====
-Starting a new spool of filament
+  * The extruder head may not pull hard enough on filament to allow it to feed properly if the filament is wound too tightly on the spool, such as when starting a brand new spool of filament.  Make sure the filament is not wound so tightly that it won't unspool when the printer is printing.
+====Change Extruder Head====
+**Note:** If you do not follow these steps, it will result in the printer not homing correctly, and can damage the print bed or extruder head.
+  - Remove filament, as per filament change instructions.
+  - Remove connector cable.
+  - Remove small hex screw at the top of the extruder head.
+  - Replace extruder head, replace screw, replace connector cable.
+  - In Cura, go to Machine > Machine Settings. Top right there is an option to "Change Tool Head"
+    - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder").
+  - Go to Machine > Install Default Firmware
+  - Good to go

Asheville Makers Wiki

Site Tools

Differences

Page Tools