This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
taz_6_3d_printer [2016/08/06 17:06] 24.182.94.75 [Usage Notes] |
taz_6_3d_printer [2018/01/24 16:23] 66.191.217.105 |
||
---|---|---|---|
Line 9: | Line 9: | ||
**Arrival Date**: June 2016 \\ | **Arrival Date**: June 2016 \\ | ||
**Working Condition**: yes \\ | **Working Condition**: yes \\ | ||
- | **Contact**: Robert S. \\ | + | **Contact**: ? \\ |
+ | **Manual**: [[https://download.lulzbot.com/TAZ/6.0/documentation/manual/TAZ-6-Manual.pdf|Click here]] | ||
====Usage Notes==== | ====Usage Notes==== | ||
* The extruder head may not pull hard enough on filament to allow it to feed properly if the filament is wound too tightly on the spool, such as when starting a brand new spool of filament. Make sure the filament is not wound so tightly that it won't unspool when the printer is printing. | * The extruder head may not pull hard enough on filament to allow it to feed properly if the filament is wound too tightly on the spool, such as when starting a brand new spool of filament. Make sure the filament is not wound so tightly that it won't unspool when the printer is printing. | ||
====Change Extruder Head==== | ====Change Extruder Head==== | ||
- | - Remove filament, as per filament change instructions. | + | **Note:** If you do not follow these steps, it will result in the printer not homing correctly, and can damage the print bed or extruder head. |
- | - Remove connector cable. | + | - Remove filament, as per filament change instructions. |
- | - Remove small hex screw at the top of the extruder head. | + | - Remove connector cable. |
+ | - Remove small hex screw at the top of the extruder head. | ||
+ | - Replace extruder head, replace screw, replace connector cable. | ||
+ | - In Cura, go to Machine > Machine Settings. Top right there is an option to "Change Tool Head" | ||
+ | - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder"). | ||
+ | - Go to Machine > Install Default Firmware | ||
+ | - Good to go |