taz_6_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
taz_6_3d_printer [2016/08/06 17:13] 24.182.94.75 [Change Extruder Head] |
taz_6_3d_printer [2018/01/24 16:23] 66.191.217.105 |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| **Arrival Date**: June 2016 \\ | **Arrival Date**: June 2016 \\ | ||
| **Working Condition**: yes \\ | **Working Condition**: yes \\ | ||
| - | **Contact**: Robert S. \\ | + | **Contact**: ? \\ |
| + | **Manual**: [[https://download.lulzbot.com/TAZ/6.0/documentation/manual/TAZ-6-Manual.pdf|Click here]] | ||
| ====Usage Notes==== | ====Usage Notes==== | ||
| * The extruder head may not pull hard enough on filament to allow it to feed properly if the filament is wound too tightly on the spool, such as when starting a brand new spool of filament. Make sure the filament is not wound so tightly that it won't unspool when the printer is printing. | * The extruder head may not pull hard enough on filament to allow it to feed properly if the filament is wound too tightly on the spool, such as when starting a brand new spool of filament. Make sure the filament is not wound so tightly that it won't unspool when the printer is printing. | ||
taz_6_3d_printer.txt · Last modified: 2020/06/20 17:08 by 108.227.249.183 · Currently locked by: 52.14.224.197
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
