taz_6_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
taz_6_3d_printer [2016/11/01 16:20] 66.190.155.97 [Change Extruder Head] |
taz_6_3d_printer [2017/01/16 11:35] 66.190.155.97 [Change Extruder Head] |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder"). | - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder"). | ||
| - Go to Machine > Install Custom Firmware | - Go to Machine > Install Custom Firmware | ||
| - | - Go to Desktop/Cura Firmware/ and select the firmware for either the Flexy or normal extruder head | ||
| - Good to go | - Good to go | ||
taz_6_3d_printer.txt ยท Last modified: 2020/06/20 17:08 by 108.227.249.183
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
