taz_6_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
taz_6_3d_printer [2017/01/16 11:35] 66.190.155.97 [Change Extruder Head] |
taz_6_3d_printer [2017/01/17 19:07] 66.190.155.97 [Change Extruder Head] |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| - In Cura, go to Machine > Machine Settings. Top right there is an option to "Change Tool Head" | - In Cura, go to Machine > Machine Settings. Top right there is an option to "Change Tool Head" | ||
| - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder"). | - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder"). | ||
| - | - Go to Machine > Install Custom Firmware | + | - Go to Machine > Install Default Firmware |
| - Good to go | - Good to go | ||
taz_6_3d_printer.txt ยท Last modified: 2020/06/20 17:08 by 108.227.249.183
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
