tongs
This is an old revision of the document!
A PCRE internal error occured. This might be caused by a faulty plugin
This is my first set of tongs. - Start with 16' of 1/2" x 3/4" mild steel. I could only find 1/2" x 1" so I had to draw it down to 1/2" x 3/4". - Make a chisel mark 1" and 2" from each end on one of the 1/2" wide faces. - Make a chisel mark 3" from each end on the opposite 1/2" wide face. -
tongs.1478881325.txt.gz · Last modified: 2016/11/11 11:22 by 162.233.141.6
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
