creator_pro_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
creator_pro_3d_printer [2019/05/29 22:21] 99.187.157.162 [Usage Notes] |
creator_pro_3d_printer [2019/11/24 16:11] (current) 136.55.187.214 [Usage Notes] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Creator Pro 3D Printer ===== | + | ===== Creator Pro 3D Printer (Zaniac) ===== |
| PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | ||
| Line 17: | Line 17: | ||
| - create your stl file | - create your stl file | ||
| - open FlashPrint - free to download on your machine; also installed on the laptop that controls the TAZ | - open FlashPrint - free to download on your machine; also installed on the laptop that controls the TAZ | ||
| - | - use FlashPrint to slice your file | + | - use FlashPrint to slice your file (basically, just load your file and generate supports if you need them) |
| - | - click on Print and select your print options | + | - click on Print and select your print options (be sure to enable supports if you added supports in step 3) |
| - | - save the g-code file to an SD card | + | - save the g-code file to an SD card (the SD card slot is just inside the printer door over the controls) |
| - | - insert the SD card into the printer and print form the SD card | + | - insert the SD card into the printer and print from the SD card |
creator_pro_3d_printer.1559168460.txt.gz · Last modified: 2019/05/29 22:21 by 99.187.157.162
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
