new_member_general_info
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
new_member_general_info [2019/07/25 13:33] 24.158.60.179 created |
new_member_general_info [2019/07/25 13:51] (current) 24.158.60.179 |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| - **Safety** - Never use equipment if you have nbot been checked out on it and you do not feel confident in your ability to use it in a manner that is safe for everyone and the equipment. If you have any questions about a machine, please ask! Other members are generally happy to help you or point you to someone who can. | - **Safety** - Never use equipment if you have nbot been checked out on it and you do not feel confident in your ability to use it in a manner that is safe for everyone and the equipment. If you have any questions about a machine, please ask! Other members are generally happy to help you or point you to someone who can. | ||
| - **Safety** - Be sure the lights are out and the space is locked if you leaving and there is no one else in the space at that moment. Don't assume someone who left is coming right back. Also, never leave the outside doors propped open after hours. | - **Safety** - Be sure the lights are out and the space is locked if you leaving and there is no one else in the space at that moment. Don't assume someone who left is coming right back. Also, never leave the outside doors propped open after hours. | ||
| + | - **Music** - We have bluetooth speakers hooked up to listen to music while working. The password to attach, if you are asked, is 1234. Please be respectful about playing music when others are using the space as well. | ||
| + | - **Free supplies** - The plastic filament for the TAZ and Zaniac printers is free for members. You may also use any laser scraps that are in the labeled scrap pile (top shelf only!) beneath the table next to the lasers. Other general office supplies such as tape, paper towels, glues, etc. are also free to members. The resin for the Formlabs printer is NOT free, and the resin is expensive, so **make sure you understand the cost and process before you print!** Members do get a free allowance for resin each month ($5). Every time you print with the Formlabs printer, make sure your name is in the filename of your print. The printer will keep a log of prints done and the amount of resin used, and we will set up each month with members who use more than $5 of resin in that month. | ||
new_member_general_info.1564061636.txt.gz · Last modified: 2019/07/25 13:33 by 24.158.60.179
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
