taz_6_3d_printer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
taz_6_3d_printer [2018/01/24 21:23] 66.191.217.105 |
taz_6_3d_printer [2020/06/20 21:08] (current) 108.227.249.183 |
||
|---|---|---|---|
| Line 24: | Line 24: | ||
| - Go to Machine > Install Default Firmware | - Go to Machine > Install Default Firmware | ||
| - Good to go | - Good to go | ||
| + | |||
| + | ====Adjust Belt Tension==== | ||
| + | Tightening the belt is hard, but this is the workflow that I found that worked: | ||
| + | - loosen up the screws on the bearing that holds the belt | ||
| + | - push that bearing forward so it loosens up the belt | ||
| + | - undo the screw that holds one side of the belt, and pull it tighter. You'll have to hold everything in place or the bed will just slide | ||
| + | - tighten the end of the belt down | ||
| + | - tighten the bearing back down | ||
| + | - if the belt is too tight now, loosen the end and let a little slack in until it seems good | ||
| + | |||
| + | It's a lot easier to add slack back in than tighten it down. | ||
| + | |||
taz_6_3d_printer.1516829002.txt.gz ยท Last modified: 2018/01/24 21:23 by 66.191.217.105
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
