This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
creator_pro_3d_printer [2019/05/29 22:16] 99.187.157.162 [Usage Notes] |
creator_pro_3d_printer [2019/11/24 16:11] (current) 136.55.187.214 [Usage Notes] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Creator Pro 3D Printer ===== | + | ===== Creator Pro 3D Printer (Zaniac) ===== |
PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. | ||
Line 15: | Line 15: | ||
The workflow for this printer is: | The workflow for this printer is: | ||
+ | - create your stl file | ||
+ | - open FlashPrint - free to download on your machine; also installed on the laptop that controls the TAZ | ||
+ | - use FlashPrint to slice your file (basically, just load your file and generate supports if you need them) | ||
+ | - click on Print and select your print options (be sure to enable supports if you added supports in step 3) | ||
+ | - save the g-code file to an SD card (the SD card slot is just inside the printer door over the controls) | ||
+ | - insert the SD card into the printer and print from the SD card |