This is an old revision of the document!
===== Laser Cutter/Engraver ===== PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. **Owner/Loaner**: Asheville Makers \\ **Donated By**: N/A \\ **Serial Number**: N/A \\ **Make/Model**: [[http://www.ebay.com/itm/High-Precise-USB-Port-Laser-Engraving-Cutting-Machine-Engraver-Cutter-60W-CO2-/262600263802?hash=item3d2432087a:g:rEIAAOSwgmJXxPA7|K60]] \\ **Arrival Date**: September 2016 \\ **Working Condition**: yes \\ **Contact**: Any Board Member \\ **Manual**: Located in bag on shelf above machine ====Usage Notes==== * DO NOT use this machine if you have not been checked out on it. Members who can check you out include Tim, Zak, Avi, and Steve. * Running the laser at full power will significantly shorten the laser life. The maximum power setting used should be 80%. * Certain materials can release dangerous and damaging fumes when cut or engraved. DO NOT cut any material unless you know exactly what the material is and that it is safe to cut/engrave. See this [[http://atxhackerspace.org/wiki/Laser_Cutter_Materials|page]] for more information. Note that this should not be considered the final authority - it is your responsibility to know what you are cutting and whether it is safe. ====Tutorials==== * [[https://drive.google.com/open?id=0ByE4uXHeoDYNUU1vM1Nuczc0Mjg|Power up and power down]] * [[https://www.youtube.com/user/SarbarMultimedia|Series of videos about using this machine and the control software RDWorks]]
