This is an old revision of the document!
===== TAZ 6 3D Printer ===== PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. **Owner/Loaner**: Asheville Makers \\ **Donated By**: Robert S. \\ **Serial Number**: N/A \\ **Make/Model**: [[https://www.lulzbot.com/store/printers/lulzbot-taz-6|LulzBot TAZ 6]] \\ **Arrival Date**: June 2016 \\ **Working Condition**: yes \\ **Contact**: Robert S. \\ ====Usage Notes==== * The extruder head may not pull hard enough on filament to allow it to feed properly if the filament is wound too tightly on the spool, such as when starting a brand new spool of filament. Make sure the filament is not wound so tightly that it won't unspool when the printer is printing. ====Change Extruder Head==== - Remove filament, as per filament change instructions. - Remove connector cable. - Remove small hex screw at the top of the extruder head.
