Site Tools


taz_6_3d_printer

This is an old revision of the document!


A PCRE internal error occured. This might be caused by a faulty plugin

===== TAZ 6 3D Printer ===== PLEASE NOTE: You may **NOT** use this machine prior to being checked out on it. **Owner/Loaner**: Asheville Makers \\ **Donated By**: Robert S. \\ **Serial Number**: N/A \\ **Make/Model**: [[https://www.lulzbot.com/store/printers/lulzbot-taz-6|LulzBot TAZ 6]] \\ **Arrival Date**: June 2016 \\ **Working Condition**: yes \\ **Contact**: Robert S. \\ ====Usage Notes==== * The extruder head may not pull hard enough on filament to allow it to feed properly if the filament is wound too tightly on the spool, such as when starting a brand new spool of filament. Make sure the filament is not wound so tightly that it won't unspool when the printer is printing. ====Change Extruder Head==== **Note:** If you do not follow these steps, it will result in the printer not homing correctly, and can damage the print bed or extruder head. - Remove filament, as per filament change instructions. - Remove connector cable. - Remove small hex screw at the top of the extruder head. - Replace extruder head, replace screw, replace connector cable. - In Cura, go to Machine > Machine Settings. Top right there is an option to "Change Tool Head" - Select the appropriate extruder head (either "Single Extruder" or "Flexystruder"). - Go to Machine > Install Default Firmware - Good to go

taz_6_3d_printer.1470518031.txt.gz · Last modified: 2016/08/06 17:13 by 24.182.94.75